1. Apply a base coat to your nails. This will help protect your natural nails from turning yellow and breaking. 2. Once the base coat has completely dried, put some Vaseline, lip balm, or scotch tape around your nail. This will make the clean up process so much easier in the end.
3. Take out as many colors that you want in the design. Use new and expensive brands. We do not want the polish to be too watery or too thick! If your nail polish doesn't spread a lot, spin the bowl so that it spreads. 4. Choose an old, unwanted bowl. The marbling process will ruin the bowl. Select carefully.
5. Fill a bowl with filtered water. Make sure it's room temperature, or keep the water out for an hour or two
6. Choose a polish and take out the wand. Don't try to remove the polish drop on the tip of the brush. Hold it over the bowl, and the drop will fall in, and quickly move across the water's surface.
7. Do the same with another polish of your desire, and drop the polish in the center of the other polish. 8. Keep alternating until desired levels are achieved.
9. Taking a toothpick, divide the design in two.
10. Make as many lines in the design as wanted.
11. When done, dip your nail into bowl wait ten seconds for the outer nail polish to dry, and take out.Then with the toothpick in a spinning motion clean the nail polish in the bowl.
12. The design should be printed onto the nail.
13. Don't worry it will be messy at first, but you can clean it up using cotton buds and nail polish remover. 14. Repeat steps for all the other nails in the same way.
15. Again clean up around them with a nail-polish remover.
16. When dry, apply a top coat.
17. Finished.
3. Take out as many colors that you want in the design. Use new and expensive brands. We do not want the polish to be too watery or too thick! If your nail polish doesn't spread a lot, spin the bowl so that it spreads. 4. Choose an old, unwanted bowl. The marbling process will ruin the bowl. Select carefully.
5. Fill a bowl with filtered water. Make sure it's room temperature, or keep the water out for an hour or two
6. Choose a polish and take out the wand. Don't try to remove the polish drop on the tip of the brush. Hold it over the bowl, and the drop will fall in, and quickly move across the water's surface.
7. Do the same with another polish of your desire, and drop the polish in the center of the other polish. 8. Keep alternating until desired levels are achieved.
9. Taking a toothpick, divide the design in two.
10. Make as many lines in the design as wanted.
11. When done, dip your nail into bowl wait ten seconds for the outer nail polish to dry, and take out.Then with the toothpick in a spinning motion clean the nail polish in the bowl.
12. The design should be printed onto the nail.
13. Don't worry it will be messy at first, but you can clean it up using cotton buds and nail polish remover. 14. Repeat steps for all the other nails in the same way.
15. Again clean up around them with a nail-polish remover.
16. When dry, apply a top coat.
17. Finished.
sumber: http://www.wikihow.com/Create-a-Marble-Nail-Effect-Using-Water
Tidak ada komentar:
Posting Komentar